This jam roly-poly is simple to make, comforting and sure to bring back memories of traditional school dinners
- Cooking Time Prep 15 mins
Cook 1 hr - Skill Level Moderately easy
- Servings Serves 6
Kcalories
330
Protein
5g
Carbs
45g
Fat
16g
Saturates
8g
Fibre
1g
Sugar
13g
Salt
0.56g
- 50g salted butter, cold and cut into chunks, plus extra for greasing
- 250g self-raising flour, plus extra for rolling
- 1 vanilla pod, seeds scraped out
- 50g shredded suet
- 150ml milk, plus a drop more if needed
- 100g/4oz raspberry or plum jam, or a mixture
- custard, to serve
- Put a deep roasting tin onto the bottom shelf of the oven, and make sure that there's another shelf directly above it. Pull the roasting tin out on its shelf, fill two-thirds with boiling water from the kettle, then carefully slide it back in. Heat oven to 180C/160C fan/gas 4. Tear off a large sheet of foil and greaseproof paper (about 30 x 40cm). Sit the greaseproof on top of the foil and butter it.
- Tip butter, flour and vanilla seeds into a food processor; pulse until the butter has disappeared. Tip into a mixing bowl. Stir through the suet, pour in the milk and work together with a cutlery knife until you get a sticky dough. You may need a drop more milk, depending on your flour.
- Tip the dough out onto a floured surface, quickly pat together to smooth, then roll out to a square roughly 25 x 25cm. Spread the jam all over, leaving a gap along one edge, then roll up from the opposite edge. Pinch the jam-free edge into the dough where it meets, and pinch the ends roughly, too. Carefully lift onto the greased paper, join-side down (you might find a flat baking sheet helpful for this), loosely bring up the paper and foil around it, then scrunch together along the edges and ends to seal. The roly-poly will puff quite a bit during cooking so don't wrap it tightly. Lift the parcel directly onto the rack above the tin and cook for 1 hr.
- Let the pudding sit for 5 mins before unwrapping, then carefully open the foil and paper, and thickly slice to serve.
0 comments:
Post a Comment